I wish to save weighing data at certain intervals. [Weighing Environment Logger] [AD-1687]
- If the balance has "interval output mode" (Models: FX-i/FZ-i, BM, HR-AZ/A)
- Using the balance's instruction manual, turn on "interval output mode".
- Change the "interval time" settings to match the interval at which you wish to record.
- Insert the balance's RS-232C cable into the AD-1687 while the power is turned off.
- Initiate interval output from the balance (example: press the PRINT key on the balance)
- If the balance does not have "interval output mode".
- Set the balance's "data output mode" to "stream mode", and set the "data output interval" to "1.6 seconds"
* Because the AD-1687 cannot keep up with the transmission rate of stream mode, the intervals will go out of sync.
It is for this reason that we advise setting to "1.6 seconds". - Insert the balance's RS-232C cable into the AD-1687 while the power is turned off.
- Immediately after the cable is inserted, one can begin recording data at 1.6 second intervals.
* Around 4 hours of data can be recorded.
- Set the balance's "data output mode" to "stream mode", and set the "data output interval" to "1.6 seconds"